12
OPERATION OF THE
ROTOFIX HIGH-
PRESSURE SPRAY
LANCE
• The RotoFix high-
pressure spray lance
allows the working
position to be
changed in pressure-
free condition.
• Push back the slide
of the locking pin
(Fig. B/4).
• Turn the screw fitting
of the RotoFix high-
pressure spray lance
until the pin engages
in the next bore.
OPERATION OF THE
FLEXOPOWERJET
NOZZLE
Turning the FlexoPower-
Jet nozzle allows the
working pressure to be
varied (Fig. C/1).
OPERATION OF THE
PRESSURE AND
WATER FLOW
REGULATOR
Wap 2200 W
• Set the pressure and
water volume by
turning the pressure/
volume regulator on
the cleaner (Fig. D/4).
Wap 2200/3300
• Set the pressure and
water volume by
turning the pressure/
volume regulator on
the cleaner (Fig. D/4)
or at the VarioPress
control knob
(Fig. B/3).
The set pressure can be
read off from the
pressure gauge
(Fig. D/5 and E/5).
USE OF CLEANING
AGENTS
• Predilute cleaning
agent as described
under „General“ and
pour into the cleaning
agent tank (Fig. F).
The intake of cleaning
agent from an external
container is possible (see
„Options“).
Cleaning agent can be
drawn in via the injector
installed as standard only
in low-pressure mode:
• Set the pressure/
volume regulator on
the cleaner to
maximum pressure
(Fig. D/4).
• Turn the VarioPress
control knob towards
„+“ up to the stop
(Fig. B/3).
• Turn the FlexoPower-
Jet nozzle towards
„CHEM“ up to the
stop.
The intaken volume of
cleaning agent can be
regulated by turning the
metering valve
(Fig. D/3 or E/3).
• Spray the object to
be cleaned.
Depending on the
degree of soiling, allow
the cleaning agent to
work. Wash down
with a high-pressure jet.
Note!
If the high-pressure hose
is extended, no intake of
cleaning agent is possi-
ble.
Do not allow the
cleaning agent to dry
on the surface to be
cleaned!
FINISHING WORK
• Turn the ON/OFF
switch to position „0“.
• Close the metering
valve.
• Turn off the water tap.
• Actuate the trigger of
the spray gun until
the cleaner is depres-
surised.
• Insert the trigger lock
(Fig. B/6).
• Remove the cleaner
plug from the plug
socket.
• Disconnect the water
hose from the cleaner.
To Next Page
Loading...