EasyManua.ls Logo

Ware Pet Products living room Series User Manual

Default Icon
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Side Panel x2
#900456
Plastic Tray #900479
Ramp
#901347
Roof Panel #900477
Bolts x8
and
Hex Wrench
#900457
Food Bowl
#900469
Front Panel #900475
Back Panel #900476
Floor Grate #902556
Shelf
#900493
Wheels x4
#900492
Step 3
Attach the Roof Panel by sliding
the right rear lower wire extension
under the support tabs and into the
hole on the Side Panel.
Slide the rest of the lower wire
extension under the open tabs
and into the hole in the left
Side Panel.
Step 2
Attach side panel with 4
more hex Bolts and
tighten all.
4 Hex Bolts
Step 1
Insert a non-locking Wheel into the Right Side Panel so
the holes line up, then insert Bolt. Align the hole in the
bottom of the Back Panel with the hole in the Side
Panel that you just placed the Bolt through. Using the
Hex Wrench, screw in the Bolt through the Side Panel
and into the Back Panel; repeat for the opposite Side
Panel making sure the tabs face towards the outside
and the tracks face towards the inside of the cage.
Attach the Front Panel in the same way, using the
locking Wheels and making sure the door opens out.
TIP: Do not tighten bolts fully until all panels are
in place.
Tracks
facing in
®
living room series
rabbit and guinea pig home
assembly instructions
item #01930
Question and Answer IconNeed help?

Do you have a question about the Ware Pet Products living room Series and is the answer not in the manual?

Ware Pet Products living room Series Specifications

General IconGeneral
BrandWare Pet Products
Modelliving room Series
CategoryPet Care Product
LanguageEnglish

Summary

Rabbit and Guinea Pig Home Assembly

Cage Components Overview

Identifies all parts included with the rabbit and guinea pig home assembly.

Step 1: Base Panel Assembly

Instructions for attaching side and back panels using bolts and a hex wrench.

Step 3: Securing Side Panels

Attaching side panels with additional hex bolts for stability.

Step 2: Roof Panel Attachment

Guides on sliding and securing the roof panel to the cage structure.

Step 4: Roof Panel Functionality

Verifies the roof panel swings freely and latches correctly.

Step 5: Floor Grate and Tray Installation

Installs the floor grate into the plastic tray and secures the tray.

Step 6: Ramp and Shelf Attachment

Attaches the plastic ramp to the shelf and installs the assembly.

Step 7: Final Setup

Places the food bowl on the shelf to complete the setup.