9
10
8
PANINI GRILL HANDLE ADJUSTMENT
INSTRUCTIONS
Your Waring Commercial Panini grill comes with a handle tension
control. This device allows you to adjust the tension on the rear
hinges with the allen wrench provided, so the top plate will remain
open at the appropriate level and maneuver to your satisfaction.
This will only need to be done a few times over the life of the product.
The following is the proper way to adjust the tension control
device (when necessary):
• Ensure that the unit is unplugged and cool before proceeding
with the following steps
• Locate the allen wrench clip (A) attached to the power cord
and remove the wrench
• Raise adjusting screw cover on back
of unit (B)
Repeat steps 7– 9 on the front of top
grill plate.
Fit the slot
over the
opposite side
of the clip.
Repeat for
second clip
on the back.
Finished Assembly
To Next Page
Loading...
