9
CLEANING & MAINTENANCE
After using the popcorn maker, let it cool completely. Use a wet
cloth to clean the housing and doors.
It is strongly recommended to clean the kettle frequently to avoid
burning excess oil onto the bottom of the inner pot.
1. Turn the power switch to the OFF position.
2. Pour 4 to 6 ounces of water (NO detergent is necessary)
into the kettle.
3. Turn the power switch to the ON position to boil the water,
allowing the stirrer to remove excess oil stuck on the
surface.
4. After about 1 to 2 minutes of boiling, allow to cool, then
pour water into a deep bowl and discard. CAUTION: THE
KETTLE IS HOT
You may also remove the kettle and clean it with a non-scratch
scouring pad. Do not immerse kettle or electrical plug in water.
Any other servicing should be performed by an Authorized
Service Representative.
To Next Page
Loading...
