WarmFlow Air Source A-Series User Manual

Page 50
Alarm
Code
Fault
Possible Cause(s)
Suggested Action(s)
Action By
User
Engineer
E081
DC Fan Motor Communication Error
There is a communication error between the fan
speed control module and the main board.
Check the wiring and connection
between the fan speed control
module and the main board.

F00
Inverter IPM Overcurrent Shutdown
Inverter IPM input current is too high.
Check the current measurement
and adjust/replace if necessary.

F01
Compressor Start-up Failure
Voltage too low.
Damage to inverter.
Check the voltage measurement.
Check the inverter for damage.

F03
Power Factor Correction (PFC) Error
There is an error with the power factor correction
circuit.
Check the power correction
wiring for a break or short circuit.

F05
DC Bus Overload
The DC bus voltage is higher than the overload
protection limit.
Check the input voltage
measurement.

F06
DC Bus Underload
The DC bus voltage is lower than the underload
protection limit.
Check the input voltage
measurement.

F07
AC Input Underload
The AC input voltage is low causing the input
current to be low.
Check the input voltage
measurement.

F08
AC Input Overload
The AC input voltage is high causing the input
current to be high.
Check the input voltage
measurement.

F09
Input Voltage Read Error
The input voltage reading is incorrect/out of
range.
Check the input voltage
measurement.

F10
DSP and PFC Communication Error
There is a communication error between the
DSP and the PFC.
Check the wiring and connection
between the DSP and the PFC.

F11
DSP Communication Error
There is a communication error between the
DSP and the inverter.
Check the wiring and connection
between the DSP and the
inverter.

F12
Inverter Communication Error
There is a communication error between the
inverter and the main board.
Check the wiring and connection
between the inverter and the
main board.

F13
IPM Over Temperature Protection
There IPM module temperature is too high.
Check the current measurement
and adjust/replace if necessary.

F14
Weak Magnetism Error
The magnetic force of the compressor motor is
too low.
Check the operation of the
refrigeration circuit in terms of
gas pressure and charge.

F15
Input Voltage Lacking Phase
The input voltage has lost a phase.
Check the input voltage
measurement.

F16
IPM Current Read Error
The IPM current reading is incorrect/out of
range.
Check the IPM current
measurement.

F17
Module/Radiator Sensor Error
A transducer has overheated.
Check the current measurement.


WarmFlow Air Source A-Series Specifications

General

Brand	WarmFlow
Model	Air Source A-Series
Category	Heat Pump
Language	English