Bracket Assembly Instructions (continued)
Plug-In Model Only
Plug the cord into a properly grounded outlet. Do NOT use an extension
cord to make the connection between the towel warmer plug and outlet.
Step 1
Hold the towel warmer in place while tightening the hex-head screws D
at the base of each section of tubing A using the smaller Allen wrench L
provided to secure the towel warmer in place.
Step 2
Make sure the unit is turned on using the ON/OFF switch located at the
bottom rail on the left side (when facing the towel warmer). A light will
illuminate the switch when the switch is turned to the “ON” position. Refer
to Diagram D for switch location.
Diagram D
Switch
9
To Next Page
Loading...