Need help?Do you have a question about the WarmlyYours TempZone and is the answer not in the manual?
General| Brand | WarmlyYours |
|---|---|
| Model | TempZone |
| Category | Floor Heating Systems |
| Language | English |
Explains the principle of radiant energy transfer and how the system warms a room.
Emphasizes careful handling to avoid damaging the heating element during installation.
States that the heating element's integrity is key and it should never be cut.
Presents different thermostat options available for the system.
Explains the function of GFCI protection for safety.
Stresses the importance of using a digital ohm meter for testing the heating rolls.
Explains how to cut mesh to create panels and make turns.
Illustrates how to make U-turns and 180° flip turns using mesh cuts.
A critical warning about not energizing the system before installation is complete.
Advises on when to perform Ohm readings: before, during, and after installation.
Explains how to record and compare Ohm readings against the UL label and warranty card.
Details how to measure Ohm resistance between conductors and sheath, and required meter settings.
Lists sequential steps for safely wiring the system components, including breaker status.
Emphasizes careful handling to prevent damage to the heating element during installation.
Warns against using continuity checkers and recommends a digital Ohm meter.
Outlines initial checks for wiring, parallel connections, and control voltage.
Guides on determining if a break or short exists under the floor after installation.
Explains how to detect breaks (infinity Ohm reading) and shorts (conductor-sheath continuity).
Lists crucial rules for maintaining the integrity of the heating element.
To Next Page