5
STEP TWO - WIRING INSTALLATION
Warning: Shock Hazard
Failure to observe these instructions could lead to
severe injury or death.
Always use properly
rounded
110v AC receptacle protected
by Ground Fault Circuit
Interrupter (GFCI).
Never remove ground pin
from plug.
Read installation and
operation instructions
thoroughly.
Never operate AC winch in
damp or wet environments.
• Connect the winch power cord to a properly grounded, 3-prong electrical
socket with a Ground Fault Circuit Interrupter (GFCI) rated at 10 amps.
• Verify that all wiring and power supply cord are positioned so that the wire
rope or moving load will not damage the cord.
• Always unplug the winch when not in use.
KNOW YOUR WINCH: Take time to fully understand
your winch and the winching operation.
Caution: To avoid property damage or injury
To Next Page
Loading...
