7
Level Controls - IOM 313 313_IOM_RevC_0418
INFORMATION PRESENT ON 313 OVERFLOW TRAP
FACTORY SERIAL
NUMBER LABEL
INSTALLATION
ORIENTATION LABEL
INFORMATION PRESENT ON 313 OVERFLOW TRAPS
PART NUMBER & SERIAL NUMBER
Information Symbol(s) Location Notes
Part number P/N On end cover • On Factory Serial Number Label attached to end cover.
Serial Number SERIAL NO. On end cover
and valve cover
•On Factory Serial Number Label attached to end cover.
• Sales order number only stamped on valve cover.*
* Number stamped using approximately 1/8 inch tall characters
INSTALLATION ORIENTATION
Information Symbol(s) Location Notes
Top of overflow trap TOP On tank •On Installation Orientation Label attached to side of tank.
Up direction UP On tank •On Installation Orientation Label attached to side of tank.
There is information present on each overflow trap ranging in importance from the part number and serial
number to numbers stamped on the tank. This information is important for identifying the overflow trap,
installing it correctly, and obtaining parts. An example of the current factory serial number label used on
313 overflow traps is shown here. The accompanying table identifies the information present and where to
find it on the overflow trap. There may also be other numbers and marks present that do not provide useful
information. Customer specific tagging may also present. The labels or plates used, and information present,
on Warren Controls other product lines or older overflow traps may be different, contact the factory for details.
To Next Page
Loading...
Need help?
General