WARRIOR Burn - Chin Strap Adjustment

WARRIOR - BURN | BURN JR HELMET OWNER’S MANUAL
1.
Pull rear velcro straps on the back of the helmet to tighten the adjustment
Helmet Fit Adjustment
2.
pad on the back of the helmet.
Chin Strap Adjustment
Then, hold the chin strap in place and adjust it by moving the strap through the
buckle, taking out any slack in the strap. Make sure you are looking straight out of
Figure 1). Repeat this process with the second temple
area strap and then the two behind-the-ear straps while keeping the helmet straight
on your head. The four straps should be adjusted so they are without slack; tight,
but again, not uncomfortable.
1.
Turn the dial on the back of the helmet clockwise to tighten the adjustment
Turn the dial on the back of the helmet counter clockwise to loosen the
2