3) Nut / Bridge
Nut:
Just A Nut III is the standard on Warwick Pro Series and Warwick Artist Series bass guitars, manufactured using high-tech
material with the best tonal characteristics, fine adjustability and stability.
Use the included 1.5 mm Allen wrench to adjust the string’s height at the nut.
TIP:
Press down on the string at the 3rd fret. Check the distance between the first fret and the string.
It shouldn’t read more than 0.3 mm / 0.01”, which equals
the thickness of a business card.
Bridge:
The Warwick 3-D Bridge features additional adjustments on top of the floating bridge height adjustment: Intonation, string spacing as well
as individual string saddle height adjustment to accommodate the fingerboard’s radius.
First loosen the locking screw (1) with the included 2.5 mm Allen wrench, the bridge is now unlocked and can be adjusted with the adjust-
ment screws (2). To adjust the height of each individual string saddle as well as adjusting the string spacing, loosen the locking screws (3)
with the included 1.5 mm Allen wrench and now the saddle is unlocked. The saddle can now be moved sideways to the left or right to obtain
the desired string spacing. In this step you can also adjust the height of each individual string saddle, and for that take the 1.5 mm wrench
and adjust the adjustment screws (4). An ideal setup is the one where the strings follow the fingerboard’s radius. You can adjust the intonati-
on screws (5) with a screwdriver. Turning the screws clockwise will increase the string’s length between bridge and nut; turning them coun-
terclockwise will decrease the string’s length. Once the setup is concluded please tighten locking screws 1 and 3 to secure it.
1
4
2
5
3
7
To Next Page
Loading...
