Washtech UD - Operating Instructions; Machine Start-up and Operation Cycles; Daily Shutdown and Cleaning Procedures

UD Operating Instructions
Start up
Fit scrap tray, wash pump filter and upstand, and shut door.
Turn wall power switch on and press machine ON/OFF Button for 1 second.
START/STOP button glows white and machine fills automatically.
Machine starts heating when wash tank is full.
START/STOP button glows orange while heating.
START/STOP button glows green when machine ready for operation.
Operation
Select Light, Medium, Heavy or Manual cycle by pressing UP or DOWN keys.
Light, Medium and Heavy cycles correspond to 60, 120 and 180 seconds cycles
accordingly.
Load rack into machine and shut door.
Press START/STOP button to start the cycle.
The START/STOP button glows red while machine operates.
Pressing the START/STOP button during operation will terminate the cycle.
When red light goes out, cycle is complete.
If Manual cycle is selected machine will continue washing until START/STOP
button is pressed again. The following rinse will complete the cycle.
Remove rack. Close door.
NOTE: The cycle time might be longer than specified if water supply
temperature is below required.
Shut down every night
Select Drain cycle by pressing UP or DOWN keys.
Remove drain upstand, close door and press START/STOP button.
Machine will drain for 100 seconds with a cleaning rinse in a middle of cycle.
When drain & clean are complete machine will go in to standby mode.
Remove filter, scrap tray, and rinse clean.
Replace scrap tray, filter and drain upstand.
Scrap tray & filter arrangement
Ensure scrap trays, upstand bracket, filter and upstand are placed as shown