Wasp WPA1200 - User Manual

To Next Page

7. Power on the 1200

The red button on the unit is the power

button. Press the button the power on

the unit.

After powering on the unit, follow the

WPA1200 onscreen prompts to set up the

unit and set the time zone. The correct

time zone is very important. Based on the

time zone you set, the date and time will

be synced with the PC each time the unit

is connected and synced.

9. Install ActiveSync software

Vista does not require ActiveSync.

Using the included Microsoft ActiveSync

CD, install ActiveSync. Follow the

onscreen prompts in the installer.

If you purchased any integrated Wasp

software, you should install that software

after ActiveSync is installed.

10. Other Accessories and Parts

There is a SD memory slot on the front of

the scanner beside the scanning window.

It is for extra memory only up to 1GB.

11. Start the Scanner

This feature is enabled by default. If you

need to manually turn it on, follow the

instructions below:

From the start menu go to Settings, then

"Control Panel". Double click on "Scanner

Settings" to open the "Scanner Control

Panel". Then click on the third tab titled

"To Kpd", select the checkbox labeled

"Start Scan2Key When Exit" and then

click the OK button to close the form.

WPA1200

Quick Start

Guide

Other manuals for Wasp WPA1200

Product Reference Guide44 pages

Need help?

Do you have a question about the Wasp WPA1200 and is the answer not in the manual?

Summary

Power on the WPA1200 Unit

Install ActiveSync Software

Other Accessories and Parts

Start the Scanner Functionality

Steps for Getting Started with Your WPA1200 Mobile Device

Unpack Device and Contents

Unpack the WPA1200 device and remove all pieces from protective packaging.

Remove Protective Film

Remove the protective film from the top and scanner windows on the front of the unit.

Open Battery Compartment

Slide the battery compartment latch and lift the door off the unit.

Install the Battery

Insert gold contacts first, ensuring terminal symbols are on top.

Prepare the Battery Adapter

Remove the black connection protector from the wall plug adapter.

Attach Stylus Retainer Cord

Attach the stylus retainer cord to the bottom of the stylus and hand strap.