What to do if my Waspper W3100VA Pressure Washer engine stops during operation?
Your Waspper Pressure Washer engine might have stopped due to several reasons: * The engine may have run out of fuel, in which case you should add fuel to the tank. * The spark plug terminal may have fallen out, so check the spark plug terminal. * The oil level in the engine might be low, so check the engine oil level.
Why does my Waspper Pressure Washer engine fail to start?
Your Waspper Pressure Washer engine might fail to start or run jerkily due to: * A clogged air filter. Clean the air filter. * The engine has run out of fuel. Add fuel to the tank. * Old fuel. Replace the fuel with fresh fuel. * The spark plug terminal is not linked. Check the fittings of the terminal on the spark plug. * A faulty spark plug. Replace the spark plug with a new one. * Fuel contaminated with water. Drain the fuel from the tank and carburettor and add fresh fuel. * Incorrect fuel mixing rate. Contact a servicing centre.
What to do if Waspper Pressure Washer has insufficient engine performance?
If your Waspper Pressure Washer has insufficient engine performance, it could be due to: * A clogged air filter. Clean the air filter. * Old fuel. Fill the tank with fresh fuel.
How to fix a Waspper Pressure Washer engine that runs smoothly when not loaded, but jerky under load?
If your Waspper Pressure Washer engine runs smoothly when not loaded, but jerky under load, the cause may be low engine speed. Adjust the position of the speed control lever and check the position of the locking screw for engine speed control.
General| Brand | Waspper |
|---|---|
| Model | W3100VA |
| Category | Pressure Washer |
| Language | English |
To Next Page