Check the status of your home from anywhere at
watchdogprotect.com
Online access is included with your device. Create a free
account on our website to check temperature, humidity, and
water presence any time 24/7. You can also manage when and
how you are alerted to any detected problems.
Access your device online
Setup complete!
When setup is complete, the light
will turn off. The device will now be
monitoring your home for water,
temperature, and humidity
problems.
Follow the steps in the
setup portal.
5
If the setup portal does not open after one minute,
you can access it with your web browser:
- Stay connected to the 'Watchdog Setup WiFi'
- Open your web browser
- Go to http://192.168.3.3
Within 30 sec of connecting to the
Setup WiFi network, the setup
portal should pop-up automatically
on your phone, tablet, or laptop.
Setup portal will open
automatically.
4
Use your phone, laptop, or tablet
to connect to the WiFi network
named 'Watchdog Setup WiFi'.
Device light turns purple to
indicate you have connected to
the device's Setup WiFi network.
Connect to Setup WiFi.
3
This will make the device
broadcast a WiFi network named
'Watchdog Setup WiFi'.
Device light turns blue to indicate
the device's Setup WiFi network
has been turned on.
Hold the button until it
turns blue. (~3 seconds)
2
Use the included USB wall
adapter. Place the water sensor
near spots at risk for water leaks
or ooding.
Device quickly ashes a green
light to indicate it has turned on.
Plug in device.
1
Follow these 5 steps...
To Next Page
Need help?
General