31 32
SETTING THE TIME
1� Pull the crown out to the 1st position�
2� Turn the crown to set hour and minute hands�
3� After the time has been set, push the crown back to the Normal position�
WINDING THE MAINSPRING
Automatic winding watch can also be wound by turning the crown in the Normal position�
Wind 15 - 20 times clockwise until seconds hand starts to move naturally�
Ligne 11-1/2’’’
Diameter ø26�00mm
Total Thickness 3�90mm
Hands 3 (H/M/S)
Jewels 24
Vibration Frequency 28,800 per hour
Accuracy -10~30 seconds/day
Running Time More than 42 hours
Winding Automatic and hand winding� The mainspring becomes
fully wound by rotating the ratchet wheel 7�5 times (turn-
ing the crown 40 times)�
Automatic Winding
Structure
Winding direction:
Clockwise (looking from caseback side)
Additional Features Front view skeleton
Shock-absorber device for balance staff
Stop second device
90S5 caliber Instructions and Specications 90S5 caliber Instructions and Specications
Hour hand
Front view
skeleton
Minute hand
Normal crown
position
Crown 1st
position
Seconds hand
To Next Page
Loading...