What to do if my Water Depot Water Filtration System is regenerating in the afternoon?
If your Water Depot Water Filtration System is regenerating in the afternoon, the settings may be incorrect. You should set the unit to regenerate at 2 AM.
Why is there sulphur coming through my Water Depot Water Filtration System?
Sulphur coming through your Water Depot Water Filtration System may be due to either too much sulphur to remove or a low pH level. Set the system to regenerate every day with a 60-minute draw.
What to do if my Water Depot Water Filtration Systems is not removing sulphur or iron?
If your Water Depot Water Filtration System is not removing sulphur or iron: 1) Check for obstructions in the backwash and check the flow restrictor. Also, try regenerating more often. 2) Check that the ozone generator is working. 3) Clean the ozone tube.
Why is there iron coming through my Water Depot Water Filtration System?
Iron coming through your Water Depot Water Filtration System may be due to a pH of 6.8 or lower, which may require a pH filter. Set the system to regenerate every day with a 60-minute draw.
General| Brand | Water Depot |
|---|---|
| Model | Blaster Soft |
| Category | Water Filtration Systems |
| Language | English |
Instructions for plumbing connections, pipe dope, Teflon tape, and solder joints.
Proper methods for connecting fittings and hand-tightening nuts.
Instructions for installing the bypass valve and related lubrication/sealant rules.
Procedure for setting the system clock after power loss.
Procedure for setting or adjusting the automatic regeneration time.
Step-by-step guide for initial configuration of system settings through two stages.
Detailed instructions for removing, cleaning, and reinstalling the CD Cell.
Diagnosing and resolving issues with sulphur and iron removal.
Resolving problems with PC board display, time, and water flow indication.
Troubleshooting incorrect regeneration timing and automatic regeneration failures.
Diagnosing and fixing issues with water quality, regenerant usage, and tank levels.
Troubleshooting water drainage and motor movement errors (E1, E2).
Resolving motor operation errors (E3, E4) and park position issues.
To Next Page