To Next PageTo Next PageWhat to do if Water I.D. Test Equipment displays Err03 (too bright)?
If your Water I.D. Test Equipment shows Err03, make sure you are using the light shield during measurement. If the issue persists, repeat the ZERO and TEST procedures.
How to fix Err02 (too dark) on Water I.D. Test Equipment?
If your Water I.D. Test Equipment displays Err02, try cleaning the measurement chamber. Alternatively, consider diluting your sample to resolve the issue.
General| Type | Photometer |
|---|---|
| Measurement Parameters | pH, Free Chlorine, Total Chlorine, Cyanuric Acid, Alkalinity, Calcium Hardness, Bromine |
| Resolution pH | 0.1 |
| Display | LCD |
| Connectivity | Bluetooth |
| Power Supply | Battery |
| IP Rating | IP67 |
| Weight | 200 g |
| Measurement Range pH | 6.50 – 8.40 pH |
| Measurement Range Free Chlorine | 0 - 10 ppm |
| Measurement Range Total Chlorine | 0 - 10 ppm |
| Measurement Range Cyanuric Acid | 0 - 100 ppm |
| Measurement Range Alkalinity | 0 - 300 mg/L |
| Measurement Range Calcium Hardness | 0 - 500 mg/L |
| Measurement Range Bromine | 0.0 – 13.5 mg/L (ppm) |
| Resolution Free Chlorine | 0.1 ppm |
| Resolution Total Chlorine | 0.1 ppm |
| Resolution Bromine | 0.1 ppm |
| Resolution Alkalinity | 1 mg/L |
| Resolution Cyanuric Acid | 1 mg/L (ppm) |
| Resolution Hardness | 1 mg/L |
| Data Transfer | App |
