What to do if my Water Pump runs and pumps out sump pit, but does not stop?
If your Water Pump runs but doesn't stop, the float switch might be stuck in the 'up/on' position. Ensure the float switch can move freely within the pit. Alternatively, the float switch may be defective and require replacement with a new one.
Why does my Water Pump run but not deliver water?
If your Water Pump runs but doesn't deliver water, the impeller or volute openings may be clogged. Remove the pump and clean these components. Also, the pump could be air-locked. Try starting and stopping it several times by plugging and unplugging the cord. Check for any clogs in the vent hole of the pump case. Ensure the check valve is properly installed, with the flapper opening in the direction of water flow.
What to do if fuse blows or circuit breaker trips when Water Pump starts?
If your Water Pump is blowing fuses or tripping the circuit breaker upon starting, it could be due to a partially clogged pump impeller, causing the motor to run slowly and overload. Remove the pump and clean the impeller. Ensure that the fuse size or circuit breaker is adequate for the pump's requirements.
Why does my Water Pump run but delivers only a small amount of water?
If your Water Pump runs but delivers only a small amount of water, it could be air-locked. Try starting and stopping the pump several times by plugging and unplugging the cord and check the discharge pipe for clogs. Also, the vertical pumping distance may be too high; reduce the distance or increase the diameter of the discharge pipe. Another possibility is that the impeller or volute openings are clogged, requiring you to remove the pump and clean them.
Why does my Water Pump motor run for a short time, then stops?
If your Water Pump motor runs for a short time, then stops, the inlet holes in the pump base might be clogged. Remove the pump and clean the openings. Also, the impeller or volute openings may be clogged; remove the pump and clean these as well.
Steps to prepare before installing the pump.
Lists materials needed for installing the sump pump.
Critical hazards causing severe injury, death, or property damage if ignored.
Important safety measures to follow during operation and maintenance.
Important cautionary notes regarding pump operation and potential damage.
Specific conditions and situations not covered by the product warranty.
General| Voltage | 220-240V |
|---|---|
| Inlet | 1 inch |
| Outlet | 1 inch |
| Frequency | 50Hz |
| Material | Stainless Steel |
| Power | 0.75 kW |
To Next Page