Owner’s Manual / Installation Guide
www.watercop.com
800-545-3636
System Description
The WaterCop
®
PRO System is designed to detect
leaks in your plumbing system at predetermined
locations, and automatically shut off the water supply
to help effectively reduce the chances of major water
damage associated with a leak.
System Components
Brass Valve: Full Port, brass, 125psi cold water,
designed for placement on incoming water main.
WaterCop Actuator: NEMA 4 (weatherproof)
Polycarbonate enclosure for indoor/outdoor installation,
AC/DC power converter with 20’ cord included, Liquid
crystal display with back light for sensor/trouble status,
ambient temperature 35°F to 105°F, for cold water
applications. Manual override, Local open/close water
control.
Flood Sensor: Power using 2 AA Alkaline Batteries
or optional AC/DC power converter (sold separately).
Batteries will provide back up power upon loss of
electricity. Wireless sensors are addressable and
supervised for conditions such as water detection,
power lost, sensor short/open and low battery. Ten foot
sensor cord allows optimal sensor placement. Flood
sensors can support one or two sensor wires. Each
WaterCop
®
PRO actuator valve can support up to 45
wireless sensors.
Range Enhancing Repeater: Enhances transmission
range of wireless sensors. Plugs into any standard wall
outlet. Receives and re-transmits sensor signals from
outlying sensors to the WaterCop
®
PRO actuator.
Monitoring Station-Standard: LCD display with back
light provides instant feedback of sensor alarm and
trouble conditions as well as open/close status of water
supply. Local push button water controls for instant on/
off of water supply. Audible alarm sounds when any
sensor detects flooding. Internal mounting bracket
mounts to standard wall boxes for aesthetics and cord
management. AC/DC power converter with 20’ cord
included.
Monitoring Station-Hardwired (pictured above):
Accommodates up to 8 zones for WPSC hardwired
flood sensors (sold separately).
NEED NEW PHOTO
To Next Page
Need help?
General