2
Table of Contents System Description
The WaterCop® Pro System is designed to detect leaks
in your plumbing system at predetermined locations, and
automatically shut o the water supply to help eectively
reduce the chances of major water damage associated
with a leak.
WaterCop® Pro (WPKxx or WPACT12Vxx) systems must
be installed indoors. For installations requiring outdoor
valve shut-o, the WaterCop® Pro Outdoor (WPKxxW or
WPACT12VxxW) system should be used. These optional
systems have an outdoor rated cable (NOT DIRECT
BURIAL) and are designated with part numbers ending
in “W”. The Water Control Panel MUST always be placed
indoors. Contact us if you have any questions about the
placement of your WaterCop® Pro.
Check the contents of the carton with the products listed
on the carton label. The shipping package should contain
the following:
• 1 each WaterCop® Pro Water Control Panel with 20'
Power Adapter
• 1 each WaterCop® Pro Actuator with attached cable to
connect to Water Control Panel
• 1 Owner’s Manual
You will also need the correct size WaterCop®-ready ball
valve (sold separately).
Read instructions before any installation is attempted. All
sections of this Instruction Manual and accompanying
Quick Start Guide should be read and completely
understood.
System Components
Water Control Panel – Standard: LCD display with back
light provides instant feedback of sensor alarm and trouble
conditions as well as open/close status of the brass valve.
On/O push buttons for local control of the brass valve.
Audible alarm sounds when any sensor detects flooding.
Internal mounting bracket mounts to standard wall boxes
for aesthetics and cord management. AC/DC power
converter with 20' cord included. Cabling of 25', 50' or 75'
is included to connect the WaterCop® Pro Actuator to the
WaterCop® Control Panel.
System Description ................................ 2
System Components............................... 2
General Safety Information ......................... 4
How the System Works ............................ 4
Operating the WaterCop® Pro ...................... 4
WaterCop® Pro Specifications ...................... 4
FCC Information ................................... 5
System Quick Reference Setting and Status.......... 5
Limited Warranty .................................. 6
To Power and Program Wireless Sensors
Powering Wireless Sensors......................... 6
Programming Hardwired Sensor Probes ............. 6
Programming Wireless Sensors ..................... 7
To Remove Sensors................................ 7
Pre-Installation Testing of WaterCop® Pro
Wiring Instructions ................................. 7
Water Control Panel ............................... 7
Installation of Sensor Probes........................ 8
Manually Testing the Valve and Wireless Sensors
Manually Test the Valve ............................ 8
Manually Test the Wireless Sensors ................. 8
Troubleshooting ................................... 9
Installation of Wireless Sensor ...................... 9
Placement of Wireless Sensors .................... 9
Wireless Sensor Battery Life . . . . . . . . . . . . . . . . . . . . . . . 10
Installation Procedure: Indoor vs. Outdoor
Selection of Valve Installation Sites .................. 10
Review the Location and Type of Main Supply Line ... 10
Additional Parts Requirements ...................... 11
Compression Fittings .............................. 11
Solder Fittings..................................... 12
Electrical Connection .............................. 12
Emergency Procedures............................ 12
Warnings and Precautions......................... 12
To Next Page