Wireless Pet Water Fountain Pro
Parts List
TYPE-C Charging Cable (No Adapter), Manual
Product Main Parts Description
External Water Pump Key/Indicator
External Water Pump
External Water Pump
Filter Tube
Base
Infrared Induction Unit
Water Tray
NSF-certified Filter
Network Configuration Key/
Base Indicator
Factory Reset Key
External Water Pump
Charging Port
Base Charging Port
Water Tank
UV Lamp
Specifications
Product Name: PAWAii Wireless Pet Water Fountain Pro
Product Model: PWF03W-W/PWF03W-R Battery Capacity: 5000 mAh
Filter Model: PWF03FU Nominal Voltage/Current: 5V , 2A
Product Weight: 2.65 lb/1200g Rated Power: 1.2W
Charging Time: 3-4h (5V/2A) Water Tank Capacity: 2L/8 cups
Product Dimensions: 10.5*5.7*7.2 inches/266*145*182 mm
Operating Mode: Plug-in/Battery-operated
Installation Instructions
1
3
2
Step 3: Assemble the soaked filter with the
water tray and place them on the water
tank. Install the external water pump onto
the water tank.
Step 4: Hold the on-off key for 3 seconds to
turn on the device. It is recommended that
the device be fully charged or plugged in
before using it.
5
min
2L
Step 2: After cleaning the water tank
and tray, put the tank on the base and
add 2L of fresh water.
Note: To ensure the accuracy of the weighing data, please do not place the device on soft ground.
Step 1: Remove the filter and tear off the
heat shrinkage film on its surface. Soak the
filter in a clean bowl of water for 5 minutes.
1 2