Components:
Specifications:
Note: Screw the ball valve onto the storage tank until tight. You don’t need to screw the ball valve to the bottom of
screw thread on storage tank.
Model: WD-PMTPressure Mini Water Tank User Manual
Thanks for choosing us.
Model: WD-PMT
Capacity: 0.26 gallons /1L
Weight: 1.56 lbs /0.71Kg
Size: 4.1*4.1*7.3 inches /113.8*113.8*185.5 mm
Working temperature: 41-100°F /5-38°C
Installation instructions
Step 1. If this mini water tank is connected to a refrigerator, Screw off the refrigerator filter, and then screw on a bypass,
which is adaptive to your refrigerator, to the filter location.
Step 2. Connect
3-way quick fitting
,
Ball valve
, and pressure mini water tank.
Step 3. a. Connect the purified water tubing of RO system to ②.
b. Cut the PE tubing at adequate length, and connect ①, ② and faucet to ⑤ separately.
c. Connect the storage tank to refrigerator with the help of ①, ⑧, ⑨, ⑩ and PE tubing of suitable length.
Note: If your water pipe is 3/8”, please contact our customer service and let us know if you have PE or metal hose.
Thank you!
1/4” - 1/4” Tee valve
Pressure mini water tank
3-way quick fitting
2
1
3
4
1/4” - 1/4” - 1/4” Tee fitting
1/4” PE tubing
Teflon tape
Sleeve*2
Insert*2
1/4” Compression hex nut*2
5
6
7
9
8
1
0
2
3
POWER
Refrigerator
Refrigerator joint
Purified water tubing
1
5
6
9
8
4
1
0
Ball valve
(with sealing washer)
Step 4. Turn on your water supply valve to fill the tank,and then drain the tank completely. How to drain the storage
tank: turn off the switch of ③ . Press the claw and pull ② off from ③. After that, invert the storage tank into a sink and
turn on the switch of ③. Then you can drain the storage tank. Your tank is now flushed and ready for normal use.
2
3
To Next Page
Need help?
General
