WaterGroup Aqua Flo - User Manual

Questions and Answers

M
Mrs. Robin BlackAug 1, 2025
Why is there no water or not enough water from my WaterGroup Water Filtration System?
- D
  Dennis SchmidtAug 1, 2025
  If your WaterGroup Water Filtration System isn't providing enough water, several factors could be at play. First, ensure the feed water and storage tank valves are fully open. Check for any blockages or crimps in the lines, and remove them if present. A clogged pre-filter cartridge can also restrict water flow, so replace it if necessary. Finally, verify that the feed water pressure at the membrane is at least 50 psi.
M
Megan MorganAug 7, 2025
What to do if my WaterGroup Water Filtration System has high product water TDS?
- C
  Charles WongAug 7, 2025
  High product water TDS in your WaterGroup Water Filtration System could be due to several reasons. Initially, the filters might not have been flushed sufficiently; approximately 5 full tanks (5 gallons) need to be drawn from the spigot to properly flush them. Also, an increase in feed water TDS can affect the product water quality. Finally, the membrane might have reached the end of its life, and in that case it should be replaced.
M
myersmelvinAug 14, 2025
How to fix low flow rate from spigot in WaterGroup Water Filtration Systems?
- Z
  zconradAug 14, 2025
  A low flow rate from the spigot of your WaterGroup Water Filtration System can occur if the air pressure in the storage tank is low. Increase the air pressure to 7 psi after draining the product water. Also, make sure the storage tank valve is completely open.
J
Jacob DavisAug 19, 2025
Why does my WaterGroup Water Filtration System have bad tasting water?
- M
  Morgan BookerAug 19, 2025
  Bad tasting water from your WaterGroup Water Filtration System may stem from several causes. The taste might be originating from the glass or plastic containers you're using. The post carbon filter cartridge could be exhausted and need replacing. Alternatively, the storage tank and/or the system might be contaminated, or the membrane life could be expired and need replacement.
X
Xavier ColeAug 26, 2025
What to do if my WaterGroup Water Filtration System has cloudy water?
- S
  stephenarroyoAug 26, 2025
  Cloudy water from your WaterGroup Water Filtration System is often due to dissolved air in the feed water becoming concentrated in the product water. This condition usually clears up over time as the feed water composition changes. Letting the water stand allows the dissolved air to dissipate, which should resolve the cloudiness.