Waterpik Water Flosser WP-462 User Manual

Insert
I
I
II
O
1
Model WP-450/462
This device is compatible with a voltage system of 240VAC, 50Hz.
FIRST USE
Charge unit for 24
hours by inserting the
charging cord into
unit.
Insert tip firmly
until it clicks
into place.
Fill reservoir with
warm water.
QUICK START GUIDE
Review full instruction book prior to first use
©2016 Water Pik, Inc.

Waterpik Water Flosser WP-462 Specifications

General

Model	WP-462
Type	Cordless Water Flosser
Pressure Settings	2
Battery Type	Rechargeable NiMH
Number of Tips Included	4
Color	White
Pulses Per Minute	1450
Pressure Range	45 to 75 PSI (3.103 to 5.171 bars)
Reservoir Capacity	7 Ounces (207 ml)

Summary

First Use

Charge Unit

Charge the unit for 24 hours by inserting the charging cord.

Insert Tip

Insert the tip firmly until it clicks into place.

Fill Reservoir

Fill the reservoir with warm water for use.

Start Water Flossing

Avoid Mess

Place the tip in your mouth before turning the unit on to avoid splashing.

Pressure Setting

Adjust pressure to LOW (I) for first use; move to HI (II) to increase pressure.

Lean Over Sink

Positioning

Close lips to prevent splashing, allowing water to flow into the sink.

Flossing Technique

Angle and Placement

Aim water at the gumline at a 90° angle, following the gumline.

Between Teeth

Pause briefly between teeth while following the gumline.