Waterpik Waterflosser WP-70 - User Manual

4
Insert
2
Pause
3
1
High
Low
Fill
Replace
No Gap
Press tip firmly into handle. When tip
is properly inserted there should be no
gap between control knob and tip.
Prior to Very First Use of Unit: Set pressure
control slide switch on handle to high, point the
tip into sink. Turn unit ON until water flows from
the tip, turn unit OFF.
For first time users, adjust pressure
control to lowest position. Gradually
increase pressure as you prefer.
Prepare the Reservoir:
Prime Unit (First Time Use Only): Adjust Pressure and Pause Control:
Remove the reservoir from base
and fill with lukewarm water.
Replace the reservoir
onto the base, PRESSING
DOWN FIRMLY
.
You can temporarily stop water flow by
pressing the pause button on the handle.
QUICK START GUIDE
Select and Insert Tip:
continued on back
Model WP-70
This device is only compatible with a voltage system of 220-230VAC, 50Hz.
Do not plug this device into a voltage system that is different.

Summary

Prepare the Reservoir

Fill Reservoir

Remove the reservoir from the base and fill with lukewarm water.

Replace Reservoir

Replace the reservoir onto the base, pressing down firmly.

Select and Insert Tip

Insert Tip

Press tip firmly into handle; ensure no gap between control knob and tip.

Prime Unit (First Time Use Only)

Priming Procedure

Set pressure to high, turn unit ON until water flows, then turn OFF.

Adjust Pressure and Pause Control

Set Initial Pressure

Adjust pressure control to the lowest position for first-time users.

Using Pause Control

Temporarily stop water flow by pressing the pause button on the handle.

On;Off Procedure

Turning Unit On

Place tip in mouth before turning unit on; lean over sink.

Technique Tips for Best Results

Gumline Technique

Aim tip above gumline at 90 degrees, follow gumline and pause between teeth.

Tip Removal

Removing the Tip

Hold control knob down and lift tip up simultaneously to remove.

Waterpik Waterflosser WP-70 Specifications