PRESSCONTROL
WALL PRO
VARIABLE FREQUENCY DRIVE FOR CONTROL AND PROTECTION
OF THE PUMP
PRESSCONTROL WALL PRO CAN OPERATE 400V THREE-PHASE PUMPS UP TO 15 HP.
Wall-mounted near the pump.
Varies the number of motor revolutions of the pump depending to the water withdrawal from the
system in order to maintain constant pressure and flow rate.
Allows to regulate the system pressure and the restart pump pressure.
Stops the pump in case of water shortage and protects it from dry running.
Is equipped with automatic restart in case of failure and anti-jamming function.
Can be installed on surface and submersible pumps.
Ensures energy saving.
Can be installed on surface pumps and submersible pumps.
Supplied with a 16 bar pressure sensor.
Standardly equipped with a communication interface to make pressure sets.
Standardly equipped with BMS protocol connection interface (Building Management System).
Standardly equipped with NFC technology for data transfer to the mobile phone.
To Next Page
General