EasyManua.ls Logo

Waterwise 8800 - Using the Countertop Distiller; Initial Distillation Setup

Waterwise 8800
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Once the bottom quarter (1/4) is wet, slowly immerse entire bag,
squeezing gently to remove air. If the bag “puffs up,” you are immers-
ing it too quickly.
Once the bag has been immersed, remove from the water and rinse it
by pouring more distilled water over bag to remove any carbon fi nes
(dust).
Install Filter
Be sure carbon is evenly distributed within bag, then place bag in fi lter
compartment ( g. D). Replace cover on compartment and place lid on
carafe. Discard rst gallon of distilled water as it may contain small, harm-
less carbon nes.
USING THE COUNTERTOP DISTILLER
Operational maintenance and replacement requirements are essential for
this product to perform as advertised.
1. Set Distiller on a dry, level, well-supported, stable surface.
2. Rinse and ll kettle to “MAX” lines with approximately 1 gallon of
ordinary tap water. DO NOT ll above “MAX” fi ll lines ( g. E).
3. Replace kettle cover. Twist clockwise to lock. Slide kettle into base unit
and press rmly to ensure kettle is properly placed ( g. C).
4. Place carafe on base unit and plug power cord into a polarized 120
volt outlet.
5. Press the ”Start/Stop” button to turn Distiller on (fi g. C). The “On
light will illuminate.
WARNING: Never remove the kettle while the fan motor is running
or for 30 minutes after a completed cycle. If cycle is interrupted, restart
and allow cycle to complete or wait at least 5 hours before removing the
kettle to allow water to cool.
6. Discard rst gallon of distilled water as it may contain some harmless
matter from manufacturing and/or packaging.
“MAX” Fill Lines
Kettle Cover
(Bottom
View)
Kettle
Gasket
Kettle
Figure E
8 Waterwise 8800 Use & Care Guide

Related product manuals