To Next Page
E
Erica NicholsonOct 28, 2025
What to do if my entire Watkins Solana is inoperative?
- JJulian CooperOct 28, 2025
If your entire Watkins Hot Tub is inoperative, start by checking the power source to ensure it's properly connected. Then, reset the GFCI. If it trips again, call for service. Also, disconnect power for at least thirty seconds to reset the heater high limit. If the problem persists, inspect the filter for clogs. If the pressure switch tripped, a clogged filter might be the cause. It will reset once water flow is restored. For frequent tripping, seek professional assistance. Ensure the spa water level isn't too low, and that filters and jet intake screens are clean. Open any closed jet nozzles or air valves. If the jet pump is running on low speed, push the JETS button twice for high speed. Burnt out bulbs should be replaced. If the heater high limit thermostat tripped, disconnect power for...
General
