WATSON BOX - Box Setup; Connection Instructions; Select Interface Language; Log In to the Service

14
BOX SETUP
ConneCtion instruCtions
• Insertthesuppliedbatteriesintotheremote.Thebatterycom-
 partmentdoorisatthebackoftheremote.Themarkingsonthe
 compartmentshowwhichwaythebatteriesshouldbeinstalled.
• (Optional)InstallthesuppliedharddiskintheWatsonbox.Turnthe
 Watsonboxupsidedown.Checkthattheconnectorsforthebox
 andharddisk(DVRMODULE)arefacingoneanother.Pushthehard
 disktowardstheconnectorsuntiltheharddiskclicksintoplace.
 ReadalsotheMotorolauserinstructionsincludedinthepackage.
• ConnecttheHDMIcableintotheWatsonbox’sHDMIportandthen
 connecttheotherendofthecabletothetelevision’sHDMIport.
 UsethesuppliedSCARTcableiftheTVsethasnoHDMIport.
• ConnectthepoweradaptercabletotheWatsonbox’spowerport
 (12VDC)andthenconnecttheotherendofthecabletoamains
 electricaloutlet.
• Connectthenetworkcable(RJ45)totheWatsonbox’sEthernetport
 andtheotherendtoanetworkterminal.
• TurnontheWatsonboxbypressingthePowerbuttonsothatitis
 in”ON”mode.
1.Selectinterfacelanguage
2.Logintotheservice
EnteryourWatsonIDintheUserIDeldandyourpasswordinthe
Passwordeld.ConrmtheIDandpasswordbyselectingConrm.
(YoucanaccessthekeyboardontheTVscreenbypushingtheOK
buttonontheremote.)
3.Selectpictureandsoundsettings
Aspectratio:TheaspectratioofamodernwidescreenTVis16:9,
whileinoldertelevisionsit’s4:3.
Aspectratioselection:
• STB(recommended):TheWatsonboxwillautomaticallyselectan
 aspectratio.
• TV:Thetelevisionwillautomaticallyselectanaspectratio.
HDMIviewingmode:IfusinganHDreadytelevision,select720P.If
youareusingaFullHDtelevision,select1080P.Ifyou’reunsure,check
yourtelevision’smanualorchecktoseeifyourtelevisionismarked
as”HDready”or”FullHD”.
Soundoutput:SelectStereoorDolbyDigitalSurround.