To Next PageTo Next PageWhat to do if the switch does not control the lights on Watt Stopper LC8-120/277 Control Panel?
If the switch does not control the lights on your Watt Stopper Control Panel, you should first check the wiring of the switch. If the wiring is correct, replace the switch. Also, ensure that the input number is programmed to control at least one relay.
Why is the LCD screen blank on my Watt Stopper Control Panel?
If the LCD screen on your Watt Stopper Control Panel is blank, check for input power and the circuit breaker. If these are okay, replace the main board.
What to do if the touch screen does not control relays on Watt Stopper LC8-120/277 Control Panel?
If the touch screen on your Watt Stopper Control Panel does not control relays, properly install the relay modules and ensure the connectors are firmly seated.
Why does the photocell turn lights off too early on Watt Stopper Control Panel?
If the photocell turns the lights off too early on your Watt Stopper Control Panel, increase the aperture size on the photocell.
Why does photocell turn lights off too late on Watt Stopper Control Panel?
If the photocell turns the lights off too late on your Watt Stopper Control Panel, decrease the aperture size on the photocell.
General| Voltage | 120/277V |
|---|---|
| Maximum Load | 20A |
| Control Type | Relay |
| Output | Relay |
| Number of Channels | 8 |
| Enclosure Type | NEMA 1 |
| Load Type | Incandescent, Fluorescent, LED |
| Operating Temperature | 0°C to 50°C |
Provides step-by-step instructions for assigning interior lighting to a schedule.
Guides users through setting up exterior lighting using astronomic inputs.
Details the steps for mounting the LC8 enclosure and installing relay modules.
Instructions for connecting single pole, single throw (SPST) loads to the relay modules.
Instructions for connecting double pole, double throw (DPST) loads to the relay modules.
Guide for connecting low voltage switches to the LC8 control panel.
How to connect occupancy sensors and photocells as inputs to the LC8.
Details the connection procedure for the EM24-D exterior photocell.
Describes the underlying principles of automatic lighting control with the LC8.
Lists and explains the icons used on the LC8's touch screen interface.
Initial steps to begin using the LC8, from logo screen to home menu.
How to manually override relay states using the touch screen interface.
Overview of the different setup menu structures available on the LC8.
Procedure for configuring the current time and date on the LC8 panel.
Instructions for setting up Daylight Saving Time (DST) on the LC8.
How to link specific relays to input signals for control.
Process for assigning relays to control channels for grouped operation.
How to associate programmed schedules with specific control channels.
Configures geographic location for accurate sunrise/sunset calculations.
Controls audible feedback from the LC8 touch screen.
Resets the LC8 panel to its original factory configuration.
Configures a schedule for basic timed ON and OFF operation.
Sets lighting to turn OFF by schedule, but ON manually.
Combines astronomic events (sunrise/sunset) with schedule-based control.
Integrates photocell input with schedule-based ON/OFF commands.
Uses the AS-100 wall switch's auto ON/OFF feature within a schedule.
Uses the AS-100 wall switch's manual ON/auto OFF feature within a schedule.
Method for creating schedule events that cross midnight.
How to configure a special schedule for holidays.
