Instruction Manual
ES-AUS1110
AUTOPowerBoard
Automatically turns off peripheral equipment
ITBoard
Energy saving made simple
MONITOR•CONTROL•SAVE
POWER On
CONTROL On
RESET
AU
TO
PowerB
oard
ALWAYSOn
CONTROL
For product support, please visit http://support.wattsclever.com
For further assistance please contact us on support@wattsclever.com
A WATTS CLEVER product
Product Speci cations
Model • ES-AUS1110 | Power rating • 240V AC 10A 50/60Hz
Maximum watts load • 2,400W | 700 joules built-in surge protection
SAA Approval • SAA120203EA
One year replacement warranty o ered with proof of purchase.
If you have any question about your warranty coverage, please contact your
installer.
Due to continual improvement in design or otherwise,
the product you purchase may di er slightly from the illustration in this book
1 YEAR FULL REPLACEMENT WARRANTY
Important Safety Notes
IMPORTANT: Please retain your instruction manual for
future use.
Watts Clever believes that the safe performance of your product is
the rst priority. We ask that any electrical appliance that you use be
operated in a sensible fashion with due care and attention placed on
the following points:
• Carefully read all instructions before operating the Powerboard for
the rst time and save for future reference.
• To protect against electric shock, do not immerse the Watts Clever
Powerboard in water or any other liquid.
• This Watts Clever Powerboard is intended for household and
o ce use only and not for industrial use.
• Disconnect from the power point and any audio visual products
before cleaning.
• Do not insert needles or any other metal objects into the socket
holes.
• Avoid moisture, extreme temperatures, shock and vibration.
• This device does not convert voltage. Do not connect country or
travel power adapters into the Watts Clever Powerboard.
• Connected plugs must be keep clean and free from defect.
• Ensure the mains plug is securely plugged into the wall socket to
avoid slipping out. Ensure cords plugged into the adaptor remain
tangle free.
• Do not exceed the maximum load of 10A / 2400W either with a
single appliance or with a group of appliance connected via a
power strip.
• Do not plug 2 or more Powerboards together
• For indoor use only.
• Always ensure the plug of any appliance is inserted fully into the
Powerboard sockets.
CARE AND MAINTENANCE
To clean the outside of the powerboard, rst switch o and remove
the powerboard from the mains power point. Then wipe with a soft,
damp cloth. Never use an abrasive cleaner or other chemicals.
TROUBLESHOOTING GUIDE
If you have any questions about this product or need any help
then please visit our support website at:
www.support.wattsclever.com
1. Overload Protection: A 10amp resettable circuit breaker. If you
accidentally overload the power use of the powerboard then this circuit
breaker will “pop” and the power will be disconnected. Once you have
removed some of the power load on the board then you can press
the reset button and the board will work again. This is for your own
protection as there is a maximum safe power load than can be used and
this safety feature stops you exceeding that.
2. Surge Protection: Surge protection is built into the board to a high level
of 700 joules, this will protect you connected equipment from surges
in power caused by lightning strikes etc. It is built in for your safety and
peace of mind, the protection system uses high quality components that
will o er ongoing protection.
Built in Safety Features
To Next Page
Need help?
General