Item # | Product Name: #302197 & 302198 Floating Dock to Pro 5 & 6 Port Connector Kit
1. Plastic connector, port to c-channel qty 2
1. Ratchet and 3/4” socket
2. C-channel steel bracket qty 2
3. Blue colored aluminum connector pins qty 2
3. 3/16 allen wrench or socket bit
4. ½” x 7” bolt qty 2, ½” nylock nut qty 2, large washer
qty 4
5. Hdwe bag: 3/8 shoulder bolt qty 2, 3/8 thin washer
qty 2
Assembly Instructions: Short C-channels are shown here, long C-channel installation is the same.
1. Determine the proper location to attach the C-channels onto the dock. If necessary all of the parts may
be assembled first to check for proper location and function on the dock. The C-channels will need to
be connected to the dock using at least four of the holes in the back of the C-channel. The hardware for
this is not provided as there are too many different attachment options.
2. Attach the plastic connector to the C-channel as shown below using the ½” x 7” bolt, ½” nylock nut and
large washers. There are numerous hole locations in the C-channel that the connector may be placed
at. Determine the appropriate hole to use so the Pro Port is level when floating on the water. Tighten
bolt and nut securely. Repeat on the other side.
Attach plastic connector using the
appropriate hole for the application.
To Next Page
Need help?
General
