EasyManua.ls Logo

WaveForm Cel-Fi GO X - Temporary Install Setup

WaveForm Cel-Fi GO X
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
Using the Antenna Position Test
The Wave app has a special “Antenna Position Test” that you
can nd under the “Settings” tab in the “Antenna Settings”
dropdown.
With each location and direction you try, you can “Capture”
results. Tests take about a minute each. Ideally, we want to nd a
location with a score of 115 or higher.
If you have very weak or low-quality signal outdoors, then it may
be hard to get over 100 or even 90. Its okay if thats the case, just
nd the best score you can. Alternatively, you might nd that the
rst location you try is over 115. Thats great! Its still worth trying
more locations to optimize for the very best signal.
Please note: don't be surprised if your antenna position score
goes down later on when you connect your internal antenna(s).
Thats totally normal!
How to Position & Aim
Finding the right outdoor antenna location and direction takes some patience, but its
absolutely worth it. Spending time to get it right will have a big impact on your system’s
performance.
Here are all the locations and directions we recommend testing your outdoor antenna:
How come we don’t recommend just using the highest point on the roof? Its simple: while
signal strength is generally higher on the roof, signal quality is often better on the side of
the building.