Need help?Do you have a question about the WaveIP GigAccess OFDM 900Q and is the answer not in the manual?
Introduction to the WaveIP GigAccess TM OFDM 900Q self-install RSU and its purpose.
Overview of the GigAccess TM OFDM 900Q system, a wireless point-to-multipoint broadband communication solution.
The RSU is a self-installed, plug and play unit requiring minimal user operation for setup.
Ensure PC has NIC and auto IP, and select an appropriate, unobstructed location for the RSU.
Connect Ethernet cable, power supply, and align RSU for optimal signal reception and polarization.
RSU auto-acquires radio channel; configure PC NIC for DHCP for internet access.
Essential safety guidelines for operating the RSU, including power, liquid, and handling warnings.
Frequency and Channels| operating frequency | 902 – 928MHz ISM band |
|---|---|
| number of channels | 21 (905 – 925) in step of 1MHz |
Data and Signal| raw data rates | 6, 18 Mbps |
|---|---|
| data throughput | Up to 5.0 Mbps for RSU |
| radio sensitivity @18 Mbps | -80 dBm, IE-2 PER1 |
Antenna Specifications| eirp | 36 dBm (max) |
|---|---|
| antenna gain | 6.5 dBi |
| antenna polarization | Vertical or Horizontal |
Interfaces and Protocols| physical interface | 2 x 10/100 Base-T (RJ-45) |
|---|---|
| protocol supported | IP, ICMP, ARP, TCP, UDP, DHCP, and HTTP |
| wireless mac interface | Proprietary based on IEEE 802.16a |
Power| power | 3.3 VDC, < 5 Watt |
|---|---|
| ac input voltage | 100 – 240 VAC, 47 – 63 Hz |
| operating temperature | 0°C - +40°C |
Dimensions| mechanical dimensions | 160 mm x 160 mm x 45 mm |
|---|
To Next Page