Wavemaster BASE User Manual

User Manual
Dear User,
we are pleased that you have chosen the BASE loudspeaker system from wavemaster and
congratulate you on this choice.
With this wavemaster BASE you have acquired a modern piece of audio technology that is in equal
measure attractive and of high quality. We are sure that this product will provide useful service and a
lot of fun to you over the coming years.
... Your wavemaster Team!
After unpacking
After unpacking you should first check that the contents are complete. In addition to this instruction
manual there should be:
2 speaker boxes
1 Speaker cable with stripped ends
1 Audio adaptor cable 3.5 mm stereo mini phono plug -> 2x RCA (Cinch) plug
Advice on location, care and safety
• Connect the audio input to the line-out, non amplified output. Avoid connection to the speaker-out
jack of your sound source. The amplified signal from the speaker-out may cause unnecessary
distortion and may damage the speaker-circuit.
• To connect your sound-system with power supply system, please make sure to have a mains socket
close to your sound-system.
• If the sound-system is not in use for a longer period of time, be sure that your system is
disconnected from mains power.
• Do not use alcohol, benzene, thinner or acids to clean the cabinet.
• Do not place your sound-system near radiators, airconditioning or radio-controlled systems.
• Avoid leaving the sound-system in permanent strain such as direct sunlight, extreme moist or
dryness, exceptional cold or heat, mechanical vibrations or shock.
• Do not open the cabinet, contact qualified personnel only.
• For service staff: Never open cabinet, when speaker system is connected to 110-240 V AC
power supply system.
• CAUTION!! Power ON / STANDBY switch does not separate mains power!
• Deliberate harm to the equipment is not covered by the guarantee.
• Please contact your dealer in case of technical problems.
1

Wavemaster BASE Specifications

Audio System

number of channels	2
amplifier output power (RMS)	2x 15W
frequency range	50 - 22, 000 Hz

Speaker Components

tweeter size	25 mm
woofer size	11.5 cm
tweeter type	mylar balanced dome

Power

mains tension	100-240 Volt ~ 50/60 Hz
standby power	<0.5 W (230V)
maximum current	0.5 A

Weight and Dimensions

width	160 mm
height	220 mm
depth	185 mm

Summary

Introduction and Unpacking

After Unpacking Checklist

Lists items to check after unpacking the system, including speaker boxes, cable, and adaptor.

Location, Care, and Safety

General Safety and Care Guidelines

Advice on connecting audio input, mains connection, disconnection for long periods, cleaning, placement, and avoiding damage.

Assembly and Operation

Connecting the Speakers and Power

Connects the left speaker to the right speaker, LINE input, and mains supply before switching on.

System Power On and Input Selection

Powers on the system via the VOLUME knob, switching between LINE and Bluetooth input modes.

System Controls and Playback

Volume, Tone, and Auto Standby

Adjusts volume, bass, and treble. System enters standby mode if input signal is low for over 2 hours.

RCA and 3.5mm Phono Playback

Connects audio sources with RCA or 3.5mm outputs to the BASE system for playback.

Bluetooth Audio Playback

Enables wireless audio playback via Bluetooth, including pairing and connection steps.

Headphones Playback Operation

Connects headphones to mute speakers; volume control works for headphones but tone controls do not.

Specifications and Compliance

Product Specifications

Details technical features including system type, drivers, connectivity, frequency range, and power.

Declaration of Conformity and Disposal

States compliance with EU directives and provides WEEE disposal information for the device.