Loading Presets and Setups
Click-and-hold on the Load button to see the Load pop-up menu. The menu is divided into four sections.
If a section is not currently available it will not appear in the Load pop-up menu.
Open Preset File… Select to open any setup or preset file, whether from the Library or your own
creations.
‘Filename.xps’: Displays any currently loaded Setup File and its presets.
Factory Presets: Displays the default Factory Presets.
User Presets: Displays any loaded User Presets.
Saving Presets and Setups
Click-and-hold on the Save button to see the Save pop-up menu. Four options are available. If an option
is not currently available it will be grayed out and inaccessible.
Save to New File… Select this to start a new Setup file. There are two prompts - first for
the setup filename, then for the preset name. You must provide a
name for both the setup file and the preset. Click OK (ENTER) to
complete the save. It is a good idea to create a folder in which to
save several setup files for a project.
Save ‘File Name’ – “Preset Name” Overwrites the settings of the loaded preset (whether a User Preset
or a preset from a Setup File) with the current settings. If a Setup
File is currently loaded, the name of the Setup File is displayed
followed by the name of the preset itself. If a User Preset is loaded,
its name is displayed.
Save to ‘File Name’ As… Saves the current settings as a new preset into the Setup file that is
open (if one is not open, the option is grayed out). You will be
prompted to give the preset a name.
Put into Preset Menu As… Save the current settings into a User Preset that will always be in
your Load menu (until deleted). You will be prompted to give this
preset a name. User Presets are stored in the plug-in’s preference
file.
Waves PuigTec EQP-1A User Manual
13
To Next Page
Loading...
