1. Basic operation of Raspberry Pi
Before using the module with Raspberry Pi, such basic operations are required:
Using Raspberry Pi image
Using Linux Terminal
If you have already known them, please skip this section directly.
1.1. How to use Raspberry Pi image
1) Download the Raspbian image from http://www.raspberrypi.org/downloads/
2) Unzip the downloaded file and get an .img file.
3) Run the software Win32DiskImager.exe then select the Image File (the .img file) and Device(The
TF Card Reader), click the button write to program the system image file. Note: The capability of
TF card in used here should be more than 4GB. In this operation, a TF card reader is also
required.
4) Plug in the programmed TF card to the TF card socket on a Raspberry Pi, and then power up to
start the Raspbian OS. (System Configuration may be required for the first time boot up)
1.2. How to use the terminal of Raspberry Pi?
All the supported software should run under the Linux terminal. If you have a HDMI monitor, just
connect it to the Pi directly then open the terminal at the GUI. If not, you can operate the terminal of
Pi using SSH.
1) Connect the Pi and a router via a network cable.
2) Run the software PuTTY on the PC connected to the router, fill the IP address and Port of the Pi.
You can get the Pi’s IP from the router. And the Port is 22 by default.
3) Connection type is set to SSH.
4) Click the button Open to enter the Pi’s terminal. At the first boot up, please input:
User name: pi
Password: raspberry
To Next Page
Loading...
Need help?
General
