SmartSensor HD
QUICK-REFERENCE GUIDE
www.wavetronix.com
801.734.7200
2
Select a mounting height
1
Ensure that all necessary components are available
You will need a number of items in order to install your sensor, including but not limited to the items below:
Use the table to select the mount-
ing height for the sensor based on
the oset from the nearest detec-
tion lane. e range of ideal osets
is highlighted in gray. If possible,
use the height contained in the
second column (Recommended
Mounting Height).
In areas with a lot of truck trac,
consider a higher mounting height
to help mitigate occlusion.
Note. is table is truncated. For
a complete table, refer to the HD
user guide.
Oset from first
Detection Lane
(ft/m)
Recommended
Mounting Height
(ft/m)
Minimum
Mounting Height
(ft/m)
Maximum
Mounting Height
(ft/m)
6 / 1.8 12 / 3.7 9 / 2.7 19* / 5.8*
10 / 3 12 / 3.7 9 / 2.7 22 / 6.7
15 / 4.6 15 / 4.6 12 / 3.7 26 / 7.9
20 / 6 18 / 5.5 15 / 4.6 30 / 9.1
25 / 7.6 26 / 7.9 17 / 5.2 33 / 10
30 / 9.1 29 / 8.8 19 / 5.8 37 / 11.2
35 / 10.7 30 / 9.1 20 / 6 40 / 12.2
40 / 12.2 33 / 10 22 / 6.7 43 / 13.1
45 / 13.7 36 / 11 23 / 7 40 / 14
50 / 15.2 39 / 11.9 25 / 7.6 50 / 15.2
*Reduction in number of reported speeds
˽ Mount bracket and Band-It clamping system
˽ Sensor cable and homerun cable
˽ Click equipment and pole-mount box
˽ Laptop with SmartSensor Manager HD, down-
loaded from wavetronix.com
˽ Bucket truck
1 Attach the mount bracket to the pole using the straps.
2 Tighten the strap screws partway. e sensor alignment will need to be ne-
tuned later, so keep the straps slightly loose.
3 Attach the sensor to the bracket; the connector at the bottom of the unit should
point towards the ground.
4 Place the lock washers onto the bolts, thread on the nuts and tighten.
3
Attach the sensor and mount bracket to the pole
To Next Page
Need help?
General
