Need help?Do you have a question about the Wavetronix SmartSensor Matrix and is the answer not in the manual?
Lists the standard components included in a SmartSensor Matrix package.
Provides key guidelines for selecting an optimal mounting location for the sensor.
Defines the sensor's 90° panoramic view for stop bar detection.
Ensures clear view for vehicle detection, avoiding obstructions.
Recommended minimum height to improve line of sight and reduce occlusion.
Guidance on sensor height based on distance to the closest lane.
Step-by-step instructions for securely attaching the mount bracket to a pole.
Positioning the sensor to cover all lanes approaching the stop bar.
Steps for plugging the sensor's 6-conductor cable into the connector.
Procedures for properly grounding the sensor unit.
Instructions for mounting the backplate within the traffic cabinet.
Steps for connecting the AC power supply to the preassembled backplate.
Explains the system surge protector and its function for cabinet equipment.
Details how to land sensor cables into plug-in terminals on the backplate.
Programming baud rate and input mapping using DIP switches on Click 112/114 cards.
How to use the rotary switch on the Click 104 for channel input mapping.
Steps to set up and connect contact closure rack cards for sensors.
Procedures for setting up the DIN rail contact closure module for each sensor.
Mapping detector rack channels to traffic phases in the controller.
Guide to downloading and installing the SSMM software on a Windows OS device.
Information on the .NET Framework requirement for SSMM installation.
Establishing a serial connection to the sensor via Bluetooth, RS-232, or RS-485.
Methods for connecting the sensor to the Internet via IP address or converters.
Using SSMM software without a physical sensor connection for setup review.
How to view status, sensor ID, type, duration, and failures of the connection.
Process for upgrading the sensor's embedded software via SSMM.
Configuring sensor description, RF channel, location, and height.
Adjusting response delay and data push settings for sensor communication.
Accessing higher-level features like wash-out time for sensor configuration.
Options to display edit area, saved configuration, or automatic configuration overlays.
The interface for manually configuring lanes and stop bars.
Process for capturing auto-configured lanes and stop bars into the edit area.
How to save lane and stop bar configuration changes to the sensor.
Adjusting sensor sensitivity thresholds for specific areas or the entire view.
How to place and adjust zone boundaries within the sensor's view.
Selecting channel types: Normal, Counting, and Pulse.
Associating sensor zones with specific output channels for detection.
Choosing channel type, mapping zones, and setting delay/extend for channels.
Specifying minimum pulse width and pulsed channel width for output signals.
How channel indicators display active zones and channel types (Normal, Counting, Pulse).
Accessing menu options for saving configuration, viewing channel info, and editing thresholds.
Procedures for backing up and restoring sensor configurations and factory defaults.
Tools for working with rack cards and contact closure devices without a sensor connection.
Tool to log vehicle detections for later playback and demonstration.
Running diagnostic tests to verify the sensor's proper operation.
Details the pinout of the SmartSensor Matrix connector and corresponding wires.
Steps for connecting AC power to the Click 600 device.
How to terminate sensor cables into the Click 600 connectors.
Connecting data bus faceplate interfaces to contact closure devices.
Using ports on the Click 600 to configure connected sensors.
Discusses how angular resolution affects detection at different ranges.
Explains signal-to-noise ratio and the stop bar effect on detection.
Discusses how occlusion affects detection performance at longer ranges.
General| Brand | Wavetronix |
|---|---|
| Model | SmartSensor Matrix |
| Category | Security Sensors |
| Language | English |
To Next Page
