Portable Rechargeable Bluetooth
Speaker and Soother
Thank you for purchasing a SoundBub. In addition to the 2 pre-set white noise
tracks, this 0+ safety rated product is designed to provide high quality wireless
sound for your mobile device, tablet, computer or other Bluetooth audio device.
This instruction booklet explains the basic operation and care of the unit.
Please read it carefully and keep for future reference. Additional information
about the SoundBub as well as digital versions of these instructions can be
found at wavhello.com
DIRECTIONS FOR USE
Please read all instructions carefully.
Micro USB
Port
Red/Green
LED
1. CHARGING THE SOUNDBUB
Plug the included MICRO USB CABLE into
the MICRO USB PORT on the lower back
panel of the Soundbub and connect the
other end to your computer or wall outlet
until the unit is charged.
• The LED light will change from red to
green when fully charged.
• The LED will blink red whenever the
battery is low.
5. HIDE-AWAY HANDLE3. PLAYING WHITE NOISE
The SoundBub comes with two preset white noise
tracks for your convenience.
Move the switch to ON.
• Press the Belly Button once to play Malibu Waves.
• Press again to play Montana Rain.
• Pressing a third time will pause the sound.
• The next press will start the cycle again.
SoundBub has a safe maximum
volume level so it never gets
too loud.
The HIDE-AWAY HANDLE makes it easy for little hands to hold or carry the
SoundBub. And it is flexible enough to conveniently hook onto a crib, stroller, car
seat or most anywhere you and your child travel.
Also, when placed on a flat surface, the handle doubles as a stand to help keep
the SoundBub upright.
CONTENTS
Micro USB Cable
To recharge your SoundBub
SoundBub
Bluetooth speaker and soother
Free music download code is located on the back cover of the WavHello booklet
(included in package)
2. TIMERS
The SoundBub comes with four TIMERS:
30, 60, and 90 minutes as well as continu-
ous play, represented by the symbol ∞.
The timers work for both the white noise
and the Bluetooth options.
• When playing white noise, the timer will
start when the BELLY BUTTON is pressed
and will reset if switched to a new track.
• When playing through Bluetooth, the
timer starts when the switch is moved to
the Bluetooth side.
• The timer will continue to count down
even if the audio is paused.
• Feel free to switch to a dierent time
limit while audio is playing.
NOTE: The continuous play option applies to when
the unit is connected to a power source. If not
connected to a power source, the running time for
the battery is approximately 2 hrs. (standby only
is approximately 120 hrs.)
INSTRUCTION MANUAL
standby
standby
voltage of battery is below 3.5V
the battery is being charged
the battery is fully charged
connected to device
Position
Switched
“ON”
white
on
on
on
slow blinking
blinking
blue
red
green
Switched
to
Bluetooth
on back
lower
panel
Color
6. LED STATUS
play sound of wave
play sound of rain
connecting Bluetooth
Description
on
on
slow blinking
quick blinking
Status
On your device, navigate to your Bluetooth settings and connect with “Sound-
Bub”. Once connected, you will hear a *beep* and the LED will change to a solid
blue. Your SoundBub is now ready to play content from the VoiceShare by
WavHello mobile app or any other content platform on your device.
NOTE: Pressing the Belly Button while in Bluetooth mode will pause and re-start
the sound.
4. PAIRING WITH BLUETOOTH
Move the switch to the Bluetooth symbol. The blue LED will blink which means it
is ready to be paired with a device.
Volume
Hide-Away Handle as Hook Hide-Away Handle as Stand
Belly Button
To Next Page
Need help?
General