What to do if LeakSmart Valve closed but now will not open on Waxman LeakSmart 8810200?
If the LeakSmart Valve closed, but now refuses to open, ensure that both sides of the Leak Sensor are completely dry.
Why does the alarm go off for no apparent reason on Waxman LeakSmart 8810200 Water Heater?
If the alarm on your Waxman Water Heater goes off for no apparent reason, it might be due to the Leak Sensor touching metal or high humidity caused by concrete sweating. To fix this, place the paper sleeve on the Leak Sensor or use a paper towel as a barrier.
How to troubleshoot LeakSmart Valve that does not operate on Waxman LeakSmart 8810200?
If the LeakSmart Valve isn't working on your Waxman Water Heater, try the following: * Ensure both sides of the Leak Sensor are dry. * Verify that there is power to the outlet. * Unplug and replug the AC Power Adapter cord from the Control Panel. * Unplug and reconnect the 4-pin connector from the Control Panel. * Check the plug connection between the Control Panel and LeakSmart Valve, unplug and reconnect it, ensuring the arrows on the sides of the plugs line up. * If an AC Power Adapter Extension Wire is in use, unplug both ends and reconnect. * Make sure fresh batteries are in the Control Panel.
What to do if no water comes out of hot side of Waxman Water Heater faucet?
If no water comes out of the hot side of your Waxman Water Heater faucet, check these items: * Push the Open button to ensure the LeakSmart Valve is open. * Confirm that the manual cold water valve is open. * Verify that a manual hot water valve hasn't been accidentally closed.
How to fix Waxman Water Heater when status light does not light?
If the status light on your Waxman Water Heater isn't lighting up, try these steps: * Ensure the outlet has power. * Unplug the AC Power Adapter cord from the Control Panel and plug it back in. * If using an AC Power Adapter Extension Wire, unplug and reconnect both ends. * Make sure the Control Panel has fresh batteries.
What to do if Leak Sensor becomes wet but LeakSmart Valve does not close on Waxman LeakSmart 8810200?
If the Leak Sensor on your Waxman Water Heater gets wet but the LeakSmart Valve doesn't close, try these steps: * Unplug and reconnect the long flat wire from the Leak Sensor. * Ensure there is power to the outlet. * Unplug and replug the AC Power Adapter cord from the Control Panel. * Unplug and reconnect the 4-pin connector from the Control Panel.
Provides crucial safety warnings regarding installation and usage, including indoor use and water-only application.
Guidance on correctly positioning and installing the LeakSmart Valve on the water supply line.
Guides users on how to test the leak detection functionality and alarm.
Addresses issues like the status light not illuminating or no water flow from faucets.
Troubleshoots problems with the valve not operating or not closing when the sensor is wet.
General| Model Number | 8810200 |
|---|---|
| Brand | LeakSmart |
| Sensor Type | Water Leak |
| Shutoff Valve | Yes |
| Installation | Easy DIY installation |
| Alerts | Audible and smartphone alerts |
To Next Page