11
CARE AND CLEANING INSTRUCTIONS
Place the Wayflex Shake It on a level surface and keep it indoors, away from moisture and
dust. Do not put the Wayflex Shake It in a garage or covered patio, or near water.
Always check your unit before each use, and ensure that all nuts and bolts are tight, and that
the unit is in good working condition.
Always turn the power off and unplug the power cord if the Wayflex Shake It is not being used.
Always remember to switch the power off and then unplug the power cord before cleaning the
Wayflex Shake It.
You can use a wet rag to clean the surface of the Wayflex Shake, but do not spray water on
the Wayflex Shake It as it may result in short circuit.
COMMON PROBLEMS AND SOLUTIONS
CAUTION:
Do not disassemble the Wayflex Shake It by yourself. For any technical issues, please
contact our service center.
The Wayflex Shake It
cannot be operated.
Check if you well put the plug in the outlet.
Check if you stitch the power on.
When the screen shows “E”, check if the stabilizers are folded up.
The wristband
remote control does
not work.
Change a new battery as the current one may run out of power.
Stay closer to the Wayflex Shake It as you may stay too far away.
The Wayflex Shake It
suddenly stops
operating.
The default duration of the Wayflex Shake It is 20 minutes, so the
power will be off automatically when time is up. You can press the
start button to operate the device again.
Note: It is necessary to rest the Wayflex Shake It for at least
15-20 minutes after use to avoid overheating. It may require longer
time to cool in warmer environments
To Previous Page
Loading...