75/269
G. Charging procedure
Recharge the scooter's battery according to the following procedure:
• The battery can be charged using a standard power outlet.
• Insert the charger plug into the scooter battery (charging
connector) by lifting the silicone cover over the charging
connector on the front right side of the footrest.
• Make sure that the charging connector is dry and plug the power
cable of the charger into a nearby power outlet.
• When charging, the LED on the charger will be red to show that
it is working correctly. When it turns green, it means that the
battery is charged.
• To finish charging, you must disconnect the power plug and then
the plug connected to the battery. Finally close the cap of the
battery socket.
• Unplug the mains plug
IMPORTANT:
• Charging for too long may shorten the life of the battery. Do not
leave your KICKWAY E1 charging overnight.
• Keep the charging environment clean and dry.
• Do not charge the battery if the charging plug is wet.
Plug the power
adapter into the
charging port.
When charging is
complete, replace
the rubber flap.
To Next Page
Loading...
