It is the setting of maximum output
voltage. If the utility voltage is usually
high and the connected equipment can
work with this condition, you can set High
Transfer Point higher to avoid UPS going
to battery mode too often.
It is the setting of minimum output
voltage. If the utility voltage is usually low
and the connected equipment can work
with this condition, you can set Low
Transfer Point lower to avoid UPS going
to battery mode too often.
If the connected equipment can tolerate
more power events, select Low Sensitivity.
The UPS will go to battery mode less
often. If the connected equipment cannot
tolerate power events, select High
Sensitivity. The UPS will go to battery
mode more often.
During a Self Test, UPS will switch from
line mode to battery mode to simulate
the power failure conditions.
If OFF is selected, the unit will mute all
alarms except for overload condition.
Select ON, the LCD will enter sleeping
mode if the display toggle is not touched
for 1 minute. To illuminate the LCD,
simply press the display toggle once.
When OFF is chosen, the LCD will never
enter sleeping mode.
Note:
In Battery Mode, the LCD is always
on.
Restore the UPS factory default settings.
LCD SETUP FUCTIONS (continued)
To Next Page
Loading...
Need help?
General
