EasyManua.ls Logo

WCM CTX8010 - Fuel System Maintenance

WCM CTX8010
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
34
Fuel system capacity of fuel tank: 7L
Parts
Quantity
Interval (h)
10
50
100
250
500
1000
2000
Drain dirt out of collector of fuel
tank
1
Check the Diesel filter
1
Change the Diesel filter
1
Check the
fuel hose.
Leakage
--
Crack / twist / others
--
Maintenance interval under normal conditions
Recommended fuel:
Merely use the quality diesel (selection of fuel grade should be dependent on environmental temperature).
Fill up the fuel
1.
Park machine on the flat ground.
2.
=Lower the bucket onto ground.
4.
Idle engine at low speed for 5min.
5.
Shut down engine Unplug the ignition key.
Caution: fuel should be disposed carefully. Before filling of fuel, shut down engine. No smoking before
filling fuel or with fuel system working.
6.
Pay attention to the fuel scale. Add the fuel if needed.
Important: keep any dirt, dust, water or other foreign material from getting into fuel system!
7.
While filling of fuel tank, make sure the fuel is not sprayed on machine and addedproperly.
8.
Put the cap back on fuel filler to avoid any lost or damage.
Inspection of Diesel filter ---every 200h
Diesel filter is used to separate the water or sediment from fuel.
Ensure the quality of diesel fuel entering the diesel engine and
prolong the service life of the diesel engine When the working time
of the diesel filter element is up and it needs to be replaced, please
change a new diesel filter .
Replacement steps
1.
Clamp the bottom of the filter with a filter element wrench and
rotate it to the left to remove it.
2.
Brush the diesel evenly on the sealing ring of the new filter.
3.
Tighten the new filter with a filter element wrench and start the
engine to check whether the seal is intact. If the oil leaks, it should be

Related product manuals