WD Plus Aplic - Getting Started; Safety Instructions and Liability Disclaimer

6 English
4. Geng started
At rst, you have to connect your device via the USB port on the charger. For
some devices, a separate connecon cable (e.g. microUSB cable) is required for
this. Then plug the charger into a properly installed socket.
Important note: Please remove the charger aer charging process from the
socket in order to avoid constant recharging of all connected devices.
5. Safety instrucons and liability disclaimer
Never try to open the device to carry out repairs or conversions. Avoid contact
with mains voltages. Do not short-circuit the product. The device is not cered
for use in the open air; only use it in dry condions. Protect it from high humidity,
water and snow. Keep it away from high temperatures. Do not subject the de-
vice to sudden changes in temperature or heavy vibraon as this might damage
electronic components. Examine the device for damage before using it. The unit
should not be used if it has received an impact or has been damaged in any other
way. Please observe naonal regulaons and restricons. Do not use the device
for purposes other than those described in the instrucons. This product is not a
toy. Keep it out of the reach of children or mentally impaired persons. Any repair
or alteraon to the device not carried out by the original supplier, will invalidate
the warranty or guarantee. The product may only be used by persons who have
read and understood these instrucons. The device specicaons may change
without any separate prior noce to this eect.