EasyManua.ls Logo

Webasto H300 entry - Maintenance

Webasto H300 entry
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
English
H300 ENTRY / COMFORT USER MANUAL
WIND DEFLECTOR (Comfort version only)
In order to reduce wind noise and buffeting the sunroof is equipped with a wind
deflector� The wind deflector will automatically pop up in SLIDE position�
SUNROLLO (Comfort version only)
In case your roof is equipped with a sunrollo, it can be can be set by hand to the
desired position (open or closed)�
When the sunrollo is closed, press the handle to release it from the frame of the
sunroof� Then, move the sunrollo backward (fig� D3)�
When the sunrollo is open, move the sunrollo forward to close it� Click the handle
into the frame of the sunroof
The sunrollo fabric is of an open mesh structure which enables a certain level of
air flow� This allows driving with the sunrollo closed for protection against direct
sunlight, while having the sunroof open to enjoy the fresh air
However, there is a limit to this� The air flow depends on the shape of the vehicle
and increases with the vehicle speed, while the maximum air flow through the
sunrollo is limited�
Due to this airflow the sunrollo will be lifted slightly and vibrate� This phenomenon
is normal and will become more noticeable with increasing speed�
For this reason we recommend to open the sunrollo with the glass panel in OPEN or
TILT position, while driving at higher speeds (> 80 km/h)� Otherwise it might happen
that air pressure dislocates the sunrollo�
MAINTENANCE
Generally, no maintenance is required�
GLASS PANEL
To clean the glass panel use only a mild, non-abrasive detergent and a brush or
sponge� When starting your journey you are advised not to open the sunroof during
the first few minutes if there is moisture on the panel� Webasto recommends first
driving with the sunroof closed until all moisture has evaporated�

Related product manuals