MultiControl | SmartControl | UniBox 9
5 Initial Start-up
5.1 Recommendations for initial start-up
WARNING
Inhalation of toxic gases in enclosed areas
Risk of poisoning and suffocation
Never use the heater in enclosed areas such as
garages or workshops without exhaust extraction
system, even in the case of programmed heating.
In workshops with exhaust extraction system,
ensure that the exhaust extraction system is
functioning.
5.2 Put the device into operation
3
Heater is correctly installed.
3
Control element is correctly installed.
Connect the vehicle power supply.
5.3 Select heater
For initial start-up
When the control element is connected for the first
time, a message about the missing setting/configu-
ration of the heater is displayed.
Fig. 07: Symbol "Missing configuration"
Press the control knob and the quick-start knob simultaneously
for 3 seconds.
+HDWHU
Fig. 08: Menu element "Heater"
Select the desired heater.
Press the control knob.
'D\
Fig. 09: Menu element "Day"
Select the current day.
Press the control knob.
Fig. 10: Menu element "Time"
Select the current time.
For manual reset
A reset returns all the settings and timer pro-
grammes in the control element to the basic set-
tings or to the default values set by the technician.
At a reset, the language setting is reset to English.
In the main menu, select the symbol "Settings" .
Settings
Fig. 11: Menu element "Settings"
Press the control knob.
Select menu element "Reset".
Reset
Settings
Fig. 12: Menu element "Reset"
Press the control knob.
Reset
Settings
Fig. 13: Menu element "Confirm reset"
To confirm the menu selection, press the control knob again.
3
The control element is restarted.
During the restart of the control element (the starting mask is
displayed for 1.5 seconds), press the control knob and quick-
start knob simultaneously for 3 seconds.
To Next Page
Loading...
Need help?
General
