4427 Dawson Street
Burnaby, B.C., Canada V5C 4B8
Office: 604.502-9007
Fax: 604.502-9044
Web: www.webbelectronicsinc.com
Document Name: MWP-302 User Manual 1 0 o f 1 7
CONFIDENTIAL, Copyright © 2018 This document is proprietary to Webb Electronics Inc. It may not be copied or otherwise
distributed without the express consent of Webb Electronics Inc.
Note: To alert the programmer when to start recording the message, a ½ second tone will sound
after the location announcement voice prompt.
Note: If the recording exceeds 15 seconds, a beep tone will sound and only the first 15 seconds
will be recorded.
Note: The location message may be replayed by the monitoring station at any time during the
conversation by pressing the #2 key on a touch-tone phone.
4.5.5 ACCESS CODE
Command #: 5
Voice Prompt: “ACCESS CODE”
Value Range: 5 digits (any of 1, 2 ,3, 4, 5, 6, 7, 8, 9, 0)
Factory Setting: 12345
Description: To program the WebbPhone from a remote location, the caller will be
required to enter a 5-digit access code. Changing the access code to a unique number
will prevent others from calling in and modifying the settings.
Note: Make sure you record your access code. Without it, you will not be able to remotely access
the phone programming.
Note: If you do forget your access code, it can be checked or reset on the WebbPhone.
4.5.6 STATION NUMBER (Analog-only)
Command #: 6
Voice Prompt: “STATION NUMBER”
Value Range: 1 – 80
Factory Setting: 1
Description: A unique number must be assigned to each WebbPhone without a
Rescue Station to allow off-site location call-ins to connect to the unit. The number is
ignored if the phone is attached to a LS-250 Rescue Station.
Note: In order for the voice prompting feature to work when calling into the WebbPhones without
a Rescue Station, one cab must be assigned as Station #1.
4.5.7 TALK TIME
Command #: 7
Voice Prompt: “TALK TIME”
Value Range: 1 – 99 minutes (Factory Setting: 5 minutes)
Description: Talk time is the length of time that the WebbPhone will stay on when a
call is made, beginning as soon as the call is answered. The unit will automatically
shut off after the programmed time.
Note: Near the end of the programmed talk time period, a voice will prompt the operator to press
the 1 key to extend the conversation. Pressing 1 (after the prompt has played) will reset the timer
and the talk time cycle will begin again.
Note: When the conversation has finished, the operator may also shut off the WebbPhone by
pressing * #.
Note: If Voice-Alert™ is activated, the recommend Talk Time would be a minimum of 10 minutes
as this controls the announcement frequency. (See discussion of Function 12 for more details).
4.5.8 PRIMARY RING TRANSFER COUNT
Command #: 8
Voice Prompt: “PRIMARY RING TRANSFER COUNT”
Value Range: 1 – 20 rings
Factory Setting: 5
To Next Page
Loading...